Page properties | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||
|
Genisys devices
Table of Contents | ||||||
---|---|---|---|---|---|---|
|
Overview
Communication Driver Information | |
---|---|
Driver name | |
Reliance | |
Assembly Name | T.ProtocolDriver. |
Reliance | |
Assembly Version | 1. |
2. | |
8. | |
0 | |
Available for Linux | False |
Devices | |
supported | |
CP3000 | |
Manufacturer | Genisys |
Protocol | Proprietary over TCP/IP | PC Requirements |
Interface | Serial and MultiSerial |
Not used in this driver.
For Slave mode, the settings are configured as follows:
On the station configuration, there are the following parameters:
Where:
For Master Mode, all parameters must be configured.
For Slave Mode, only IP and Slave ID parameters must be configured.
The syntax for the Genisys communication point is:
When configuring the write address points, they must be in a WriteGroup since the communication always sends all 8 bits at once.
To configure the WriteGroup AccessType:
5. After configuring the AccessType, go to Devices → Points.
6. Set the Control points to the newly created AccessType.
When using the Genisys driver in Slave Mode, the Points must be configured for an AccessType with some specific configuration parameters.
To configure this AccessType:
4. After the configuration of the AccessType, go to Devices → Points.
5.Set the Control points to the newly created AccessType.PLCType:Set this field with the target PLC type. Available options are: A15, A20, A30, A30E, A40, A40E.
PLCStation: Identifies which station will be communicated with. Default value is 1.
SlotDest: Defines the communication moduledestination slot position in the Reliance rack. Default value is 0.
Station syntax: <PLCType>;<PLCStation>;<SlotDest>
Ex: com1;A15;1;0
Station syntax: <ComPort>;<PLCType>;<PLCStation>;<SlotDest>
Where : <ComPort> = COM Port of the slave device in the network (default is com1).
Ex: com1;A15;1;0
The syntax for the Reliance communication points is: <Command>:<Address>
Where:
Reliance Driver |
---|
Revision History | |
---|---|
Version | Notes |
1. |
2. |
8. |
0 | Initial release on new documentation standards |
Page Tree | ||
---|---|---|
|