TSecureGateway provides a secure way to manage communication between multiple systems. It enables both one-to-one and one-to-many connections, ensuring that only authorized traffic passes between designated points. For installation instructions, refer to the Installation-WebGateway section of the manual. After installation, start the WebGateway service and monitor log messages in the Windows Event Viewer for connection details.
On this page:
Introduction the TSecureGteway
Our Secure Multi-Port Gateway ensures secure communications between multiple projects, nodes, or other systems you want to communicate with.
How to Use the Secure Multi-Port Gateway
Ensure secure communications between multiple projects, nodes, or other systems you want to communicate with via our Secure Multi-Port Gateway.
Setup 1-to-1 communications to a single site, or setup 1-to-many communications for multiple sites running into the same "master" project.
In the example below, we created a business level project that can send requests to any site of a group, and all the traffic is handled via our Secure Multi-Port Gateway.
Our Secure Multi-Port Gateway ensures safe data communications by only allowing the traffic that is supposed to go from point A to Point B, Point A to Point E, and so on, all while keeping the sites apart from each other.
Installation
Refer to to Installation-WebGateway section of this manual, located here.
Starting the Service
When the WebGateway service is started, log messages are in the Windows EventViewer.
Below is a message similar to one of the log messages.
First redirect :: LocalPort: 3101, RemoteIP: localhost, RemotePort: 3101,RemotePortWA: 3102 Extra Redirection Table: Listen on ipv4: Connect to ipv4: Address Port Address Port --------------- ---------- --------------- ---------- 0.0.0.0 3100 192.168.80.129 3100 0.0.0.0 3102 192.168.80.129 3101 |
In this section: