DanLoad8000 driver implements communication with Daniel Measurement and Control on TCP/IP or serial networks.

On This Page:

Overview

DanLoad8000 driver implements communication with Daniel Measurement and Control on TCP/IP or serial networks.

Configuration

Channels Configuration

Protocol Options

• BlockSize: Defines the maximum amount of items per group, the default value is 250.

If the communication points are configured in sequence and the BlockSize equals to 250, the driver can create the internal groups with 125 Registers or 2000 Coils.

• Encoding:  Determines how the information will be packed into the message fields and decoded. The options are:
  • RTU: Remote Terminal Unit mode, where each 8–bit byte in a message contains two 4–bit hexadecimal characters
  • ASCII: The message is encoded in ASCII mode, where each 8–bit byte in a message is sent as two ASCII characters
  • RTU TCP: The default transmission mode when the message is carried on a DanLoad8000 TCP/IP network. It contains information to allow the recipient to recognize message boundaries even if the message has been split into multiple packets

• SingleWrite: Indicates the driver behavior for the writings with only one item:
  • Use block write : The driver uses the 0x0F command for Coils, or the 0x10 command for Holding Registers
  • Use single write: The driver uses the 0x05 command for Coils, or the 0x06 command for Holding Registers
• SlaveID: Defines the driver Server address in the DanLoad8000 Network.

Settings

• Serial and MultiSerial channels:

Default configuration:

DataBits: 8.

StopBits: 1 if parity is used, 2 if no parity.
Set the other fields according to your Serial or MultiSerial port configuration.

• TCP/IP channels:

NodeConnections: Defines the maximum number of parallel requests that will be sent to each node (asynchronous communication).

Nodes Configuration

Station Configuration 

SlaveId: Set this field with the address of the slave device in the DanLoad8000 network. They can be addressed from 1 to 247 for serial nodes, or 0 to 255 for TCP/IP nodes. The address 0 is used for the broadcast.

• Serial channels:

Station syntax: <SlaveId>
Ex: 1

• MultiSerial channels:

Station syntax: <ComPort>;<SlaveId>

Where : <ComPort> = COM Port of the slave device in the DanLoad8000 network (default is com1).
Ex: com1;1

• TCP/IP channels:

Station syntax: <IP address>;<Port number>;<SlaveId>

Where : <IP address> = IP address of the slave device in the DanLoad8000 network < Port number > = TCP port where the slave device is listening (default is 502).
Ex: 192.168.1.1;502;1

Points Configuration

The syntax for the DanLoad8000 communication points is: <Operand><Address>

Where:

• <Operand>: indicates the memory area
• <Address>: indicates the data address in the memory area, from 1 to 65535

E.g.: 40001 (Operand = Holding Register, Address = 1)

Driver Revision History

In this section...