This document has only specific information about the device connection settings and its address syntax.
Refer to the User Guide for more information on the Device Module.
On this page:
Summary
Communication Driver Information | |
|---|---|
Driver name | SNMP |
Assembly Name | T.ProtocolDriver.SNMP |
Assembly Version | 2.5.0.7 |
Available for Linux | False |
Devices supported | SNMP supported devices |
Manufacturer | N/A (Not Applicable) |
Protocol | SNMP |
Interface | TCP/IP or UDP |
PC Requirements | Ethernet port |
Supported Operands
Get Command
Command | Description |
|---|---|
OctetString | FS Device DataType ASCII |
ObjectIdentifier | FS Device DataType ASCII |
TimeTicks | FS Device DataType ASCII |
Integer32 | FS Device DataType Long |
Gauge32 | FS Device DataType DWord |
Counter32 | FS Device DataType DWord |
Set Command
Command | Description |
|---|---|
OctetString | FS Device DataType ASCII |
Integer32 | FS Device DataType Long |
Counter32 | FS Device DataType DWord |
Nodes Configuration
Station Configuration
- <IP address>: IP address of the equipment in the network
- <Port>: Port of the equipment in the network
- <MIB>: MIB file of equipment. If the MIB file is not specified the SNMPv2-MIB file will be used.
- <Version>: Version of the SNMP
- <Authentication>: Authentication MD5 or SHA-1. Only for Version 3.
- <Passphrase>: Passphrase when Authentication is enabled.
- <Privacy>: Privacy DES or AES. Only for Version 3 and Authentication is enabled.
- <Passphrase>: Passphrase when Privacy is enabled.
- <UserName>: UserName for version 3.
Points Configuration
The syntax for the SNMP communication points is: [Community name]; <OID>
Where:
- [Community name] can be:
- Public (default)
- Private
- <OID>: indicates the Object Identifier (OID) in the verbose notation. You can use the TreeView to select the OID from MIB.
E.g.: .iso.org.dod.internet.mgmt.mib-2.transmission
Driver Revision History
SNMP Revision History | |
|---|---|
Version | Notes |
2.5.0.7 | Initial release on new documentation standards. |